Power and pneumatic tools are a practical way to complete many assembly tasks when you work in the specialty vehicle industry. There's a reason why they're found on nearly every work bench you encounter – they increase productivity, helping you accomplish more in less time

As with any piece of equipment, workers need to be trained to use each tool that their job requires. This training should also include safe working procedures, potential hazards, and wearing the right safety supplies such as hard hats, safety glasses, and work boots.

One of the most common mistakes that people make with power tools involves their power cords. Tools should never be carried by the cord. It puts too much strain on the connection point, increasing the possibility of a malfunction and possibly damaging the tool.

When disconnecting the cord from an outlet, the tool should be turned off and the plug should be firmly grasped and pulled from the outlet. Plugs should never be removed from an outlet by yanking on the cord. Also, power tools should be turned off and disconnected from their power source whenever they're not in use.

Air tools are powered by a compressor that supplies compressed air. The greatest danger of pneumatic tools is getting hit by an attachment or a fastener being used with the tool. In addition to using safety clips or retainers on pneumatic tools, screens or shields are required to protect nearby workers from flying fragments around chippers, riveting guns, staplers, and air drills.

Damaged tools shouldn't be used until they're repaired. Setting aside a broken tool alone isn't enough to deter other staff members who might not understand that it's dangerous. When a tool is set aside for repair or service, it needs to be clearly tagged "Do Not Use" or locked away to prevent use and possible injury.

Maintaining solid footing is very important for staying safe. Many power tool injuries come from workers slipping and falling while they're using a drill, saw, or sander. Workers' feet should be firmly planted shoulder-width apart, and the floor or ground needs to be clear of debris to reduce trips and falls when using power tools.